Add each print location, set the size, and upload the file (max 20 MB) or paste a cloud link on that location. We preview it and warn if it looks out of spec. Templates & specs
Add your artwork to continue.
Our vertical Wall Mount Pole Banner Brackets are able to hold 30" wide banner prints. The mount has 6 pre-drilled holes to provide a variety of ways to complete installation with the use of straps, screws, and bolts.
Includes:
- 1 Double-Sided Banner Print
- 2 Aluminum Mounts
- 2 Fiberglass Rods
- 2 Rubber End Caps
- 2 Aluminum Rings
- 2 Aluminum Pins
Features:
- Aluminum cast mount for installations on walls, flat surfaces and light poles
- 3/4" Fiberglass Rods to reduce wind load
- 2-7/8" x 4-7/8" Aluminum Mount with 6 pre-drilled holes
- Fiberglass rods include rubber end caps to secure banner prints in place
- For banners up to 30" wide
- Grommets are Placed at all 4 Corners of Banner
Caring for Your EZ Ink Print
Follow these steps and your print will last 50 to 70+ washes.
- Wash inside out in cold or warm water.
- Use a mild detergent. Skip bleach, fabric softener, and harsh chemicals.
- Tumble dry on low or hang to dry. Avoid high heat.
- Don't iron the print directly. If you need to iron, turn the shirt inside out and lay a towel between the iron and the print.
Why low heat matters: High heat softens the adhesive that holds the print to the fabric. One hot cycle by mistake usually won't ruin your print. Repeated hot washes and dries can cause cracking, peeling, lifted edges, and faster fading.
Thanks for choosing EZ Ink!